***33% OFF stock cleaning special!***
*** Fully satisfactions guarantee! We accept return for no reason within 14 days after product received! (With Buyer's return fee)***
*** <30 days oversea shipment promise! If the item cannot be delivered within 30 days, we will setup refund immediately!***
Reduce filament stoppage failure for MakerBot Replicator 2 & 2X!!
Smart Filament Holder Features:
- Universal Fitment to most filament spools! No more bundled by original expensive filament spool!
- No more out of bounds wire wrapped failure! (Photo #6)
- 4 bearings to reduce 30% friction force to avoid filament jam failure during printing. (Photo #7 #8)
- Plug and play! Not need to modify your machine!
- More easier to replace filament spool!
- Made by 5052 aluminum in well strength.
- Does your machine have filament jam problem all the time?
- Do you wish to use other filaments but limited by the filament holder due to different spool hole diameters?
Thanks for My Yard Technology! Here is the solution for MakertBot 3D printer players! We design & make this by light weight 5052 aluminum in 2.5mm thickness to enhance your printing experience! It reduce your filament wire stoppage failure significantly!
1. Fit printers:
- MakerBot Repliator 2
- MakerBot Replicator 2X
2. Accept Spool width to 86mm maximum (almost fits to all spools)
4. 4 high quality bearings
5. Filament friction force <100g (30% reduced)
1. 1 complete smart filament holder
2. User manual
***You will get product shown in Photo 2.***
***$10 shipping to worldwide by registered air parcel!***